MaxxECU Race C1 Harness

MaxxECU 8HP (GEN1) cable harness (BMW 8HP shifter)

MaxxECU Race for BMW M54 (MS42/43)
This is a Plugin harness with MaxxECU Race included

MaxxECU RACE harness 2 (EGT, E-Throttle, extra)

CAN based keypads from Blink Marine in Italy using the J1939 CAN protocol.

Full support in all MaxxECU units.



No icon packs are included, must be bought separately Pre programmed with J1939 CAN standard which MaxxECU uses.

CAN based keypads from Blink Marine in Italy using the J1939 CAN protocol.

Full support in all MaxxECU units.



No icon packs are included, must be bought separately Pre programmed with J1939 CAN standard which MaxxECU uses.

CAN based keypads from Blink Marine in Italy using the J1939 CAN protocol.
Full support in all MaxxECU units.

No icon packs are included, must be bought separately Pre programmed with J1939 CAN standard which MaxxECU uses.

Maxxecu Connector Small terminals

Made to fit the Dodge 8HP shifter, if using another CAN shifter, the connector needs to be cut and changed.
The OBD connector is there for future flash/tuning purposes.
1800mm between the shifter and the GT150 connector.
2100mm between the 8HP connector and the GT150 connector.

CAN based keypads from Blink Marine in Italy using the J1939 CAN protocol.

Full support in all MaxxECU units.



No icon packs are included, must be bought separately Pre programmed with J1939 CAN standard which MaxxECU uses.

CAN based keypads from Blink Marine in Italy using the J1939 CAN protocol.

Full support in all MaxxECU units.



No icon packs are included, must be bought separately Pre programmed with J1939 CAN standard which MaxxECU uses.

MaxxECU MINI / RACE C2 / PRO C4 (32-pin molex) with pins (8 grosses pins + 24 petites pins)

Exhaust gas temperature sensor 1.8m 4.7mm covered tip

MaxxECU PRO / RACE H2O USB-cable 1.5m

Nissan 200sx S13 CA18 MaxxECU STREET Plugin EXTRA

Connector 10-way socket housing (Dodge Shifter)

Intake temperature sensor (IAT) 1/8 NPT (Open element)
Requires DTM 2 pins connector not included.
Calibration:
0deg C = 9.256ohm
150deg C = 46.7ohm

Connecteur Deustch DTM 2 pins Male Housing with pins

Temperature sensor 1/8 NPT CLT (water / oil) (Closed element).
DTM 2 pins Connector not included.
Calibration:
-20deg C = 15.462ohm
130deg C = 89ohm